This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connecting things up....
Hi all

I have been playing with WAGO connectors for the boat.
I need glasses for fine work, and not fond of soldering - especially as I take the pi (and sometime other components) home for messing about/testing.

Wago connectors seem to be a good solution for wiring - but be careful with the sizing - data wires need fine connectors.

They seem to beat the old screw type connectors (I might later move some of the buses - especially for 5v connectors).

I was concerned about water ingress - even moisture in the cabin.

I have found an IPx8 type box for these which I will test.  you can find them here:

Basic fine wago are here:

hope that this helps!  If anyone feels that there is a problem here, please let me know.


Forum Jump:

Users browsing this thread: 1 Guest(s)