This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I2c Adress with TCA9548A
#1
Please help,

i want to use the  TCA9548A I2C multiplexer to read 4 BMP280 sensors.

But the I2C tool shows me only one I2C adress (0X71) instead of the 8 adresses of the multiplexer.

0  1  2  3  4  5  6  7  8  9  a  b  c  d  e  f
00:                         -- -- -- -- -- -- -- -- 
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
70: -- 71 -- -- -- -- -- -- 




so, where is this to change, that i can define the right adresses in the ic2 tool, soi can use signal-k for the sensors on the multiplexer ?

thank for your help





sorry for my english, i'm austrian
Reply
#2
I have no experience with that module but I think you just need one address to get data from your 4 bmp sensors. That is what a multiplexer does. Anyway, I am not sure that the TCA9548A will work with the current OP I2C app. Connecting the 4 bmp sensors in parallel using different addresses would work.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)