This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 2 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OpenPlotter 3 roadmap
(2022-07-26, 10:09 AM)Sailoog Wrote: after signal k server installation, a systemctl service is created and you need the user there. If you change the user "pi" you just need to re-install signal k and the systemctl service will be overwritten with the new user.

In the near future you will be able to set the user and lots of parameters before requesting customized images that will be built on the fly:

Thank you so much for the clarification Sailoog, really appreciated
Hi Guys, 

First of all, massive thanks for all the effort and dedication you put into this project!

I have a question regarding a trip I'm planning. We would leave next weekend but I wanted to use the SDR VHF app from OP to receive some AIS signals from boats around me. Given the fact that this app is not supported yet on OP3, is it better to keep using OP2 with the SDR VHF app, or is there a way to use OP3 yet install the old SDR VHF app?

thank you for your insights!
I would recommend to keep OP2
After Sailoog suggestion, I got openplotter3 running. I have replicated all the settings I had on op2 and everything seemed fine. I manage a lithium battery bank using nodered and an external application that polls the batteries bmses, send data and alarms to mqtt, and I display them on a tablet dashboard. So far so good.
With op3, it works fine for a while and then it loses the bmses connection, so that I lose the bank data.
Rebooting it starts working again and eventually it fails again.
Currently I reverted to op2, but some nodered nodes need to be updated and I cannot because node and npm versions are too old. Any suggestion on how to proceed?
Thanks in advance
It would be good to be able to enter a device type ina226 or ina260  that its reading is type 20 amp well we know that in 12v.  the amperage is high. As the ina219 does not read more than 3 amps, that is very little in 12v. I always felt the lack of a device that could measure high amperages in Signalk. 

In openplotter v2 ina260 not working in signalk with kip , not read , you add in openplotter i2c  but signalk not read the device.and kip dont show nothing.

Excellent work, my congratulations to the whole team

Forum Jump:

Users browsing this thread: 2 Guest(s)