This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(Solved) No GPS data to Opencpn unless Route is active
#1
Hi,
I have my GPS connected to SignalK plus my wind, depth etc to signalK also.  I am sending RMB and RMC from Opencpn to signalk.  I have tried SignalK protocal to Opencpn and also a TCP connection (so that I can stop RMB and RMC looping).
Either  methods of sending data from Signalk to Opencpn result in no GPS data to Opencpn unless a Route is active. All the other data from the NMEA 182 instruments transfer whether a route is active or not.
Any ideas as to where I am going wrong?
Jodel
Reply
#2
(2022-02-04, 11:34 PM)Jodel Wrote: Hi,
I have my GPS connected to SignalK plus my wind, depth etc to signalK also.  I am sending RMB and RMC from Opencpn to signalk.  I have tried SignalK protocal to Opencpn and also a TCP connection (so that I can stop RMB and RMC looping).
Either  methods of sending data from Signalk to Opencpn result in no GPS data to Opencpn unless a Route is active. All the other data from the NMEA 182 instruments transfer whether a route is active or not.
Any ideas as to where I am going wrong?
Jodel

When I was setting up th GPS in SignalK "Suppress 0183nmea" was on yes by default.
I selected no and that solved the issue.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)