This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
rudder feed back Hall sensof
RP! 4 with latest openplotter 
I am at home fiddling around with the goal to make a pypilot for a motorsailor 14 000 kilo with old cetrex hydraulic autopilot. The mechanic relais contactpoints are weare out, so time to upgrade. So the software openplotter and the imu (mpu 9250) is working. Next motor ino for the nano atmega328p. I downloaded the latest with braking. [Image: 2342579?s=48&v=4]

[color=var(--color-fg-muted)]    seandepagnier Merge[/color]
As rudder feedback I have a AVX 91681 000 10
Now question: What resistance have I to fill in in the motor sketch?  As pot 5Kohm and do calibration later? 
There is no resistance to fill out as the rudder feedback is just an analog voltage.
(2022-03-19, 06:08 PM)seandepagnier Wrote: There is no resistance to fill out as the rudder feedback is just an analog voltage.

Thanx. So 0.5 volt  will be starboard and 4.5 volt  port ratiometric.
This should do fine. The resolution is approx 1/1023 of 5 volts.. so usually about 0.1 degrees for rudder position.

Forum Jump:

Users browsing this thread: 1 Guest(s)