2023-02-08, 02:52 PM
(2023-02-08, 07:33 AM)Sailabout Wrote: @Techstyle Thank you for your answer
Well, I am not that far as having sensors connected except for a BME280. But even without temperature oneWire sensors connected, I expect(ed) to see the paths mentioned in the PatformIO serial monitor and in the data browser of Signalk with no or a zero value shown for each path:, the same that I have for the RPM (and fuel flow) and oil pressure although no sensors for them are connected to the ESP32 either. The oneWire dependency in the .ini file was not forgotten.
I have run the ESP32 with oneWire sensors before with success (based on https://randomnerdtutorials.com/esp32-mu...e-sensors/) but never in the context of SensESP.
On the IP address for the device, configuration page, I see "Device found false" for the oneWire sensors so I guess I need them connected to have results. I shall have to wait until I am home to continue the project . . . .
By the way, I run PlatformIO on a Raspberry Pi 4 (with OpenPlotter3 64b), it is slow but works well . . . .
Regards
Paul
in SensESP, you don't see an entry in Signal K unless you have a sensor connected.
in the video I did, https://youtu.be/Zay2ALtgxzc, if you look at about 13:30, you will see there are no one wire sensors hooked up and no entry in Signal K, in the later demo (16:00) there is one hooked up (oil Temp) and I am getting data in signal K (although I only show it in KIP)