Ok, so you will never encounter this problem with a hall sensor, only with (some) potentiometers.
I will add those extra resistors on my board, maybe you should also do the same on the next revision of your controllers...
FWIW, two resistors of 510 ohm, one on each potentiometer end (+5V and GND) do the job for me.
I will add those extra resistors on my board, maybe you should also do the same on the next revision of your controllers...
FWIW, two resistors of 510 ohm, one on each potentiometer end (+5V and GND) do the job for me.