This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Basic IMU/I2C setup question
#5
Okay, I did get the nmea generator generating the **HDG sentence last night. However, even though navigation.headingMagnetic (Pi is on boat, this syntax from my memory) shows up in signalk, the value is static in the signalk diagnostic view (355.xx) and the data is 0.0 in the HDG sentence. When I go into the calibration stuff for the IMU the sensor is clearly working. Did I miss a step?
Reply


Messages In This Thread
Basic IMU/I2C setup question - by jswalwell - 2017-04-05, 06:49 PM
RE: Basic IMU/I2C setup question - by dreuf - 2017-04-05, 07:44 PM
RE: Basic IMU/I2C setup question - by jswalwell - 2017-04-05, 07:52 PM
RE: Basic IMU/I2C setup question - by PaddyB - 2017-04-06, 10:41 AM
RE: Basic IMU/I2C setup question - by jswalwell - 2017-04-06, 02:14 PM
RE: Basic IMU/I2C setup question - by jswalwell - 2017-04-06, 07:09 PM
RE: Basic IMU/I2C setup question - by abarrow - 2017-04-07, 08:01 PM
RE: Basic IMU/I2C setup question - by jswalwell - 2017-04-07, 08:20 PM
RE: Basic IMU/I2C setup question - by abarrow - 2017-04-07, 08:50 PM
RE: Basic IMU/I2C setup question - by abarrow - 2017-04-08, 04:41 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)