This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
Radar compatibility

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Radar compatibility
Dogfood Offline
Junior Member
**
Posts: 1
Threads: 1
Joined: Apr 2022
Reputation: 0
#1
2022-04-25, 03:40 PM
The guy on the boat next to me is selling a JRC 1000w scanner model JMA-1011. The conector has been cut off but i dont think it was an ethernet. The service manual gives lots of information https://www.manualslib.com/download/1991...mk-Ii.html just wondering if i can stick an ethernet plug on (and how to wire it) and be up and running?

Thanks
Mike
Find
Reply
abarrow Offline
Moderator
*****
Posts: 579
Threads: 65
Joined: Nov 2016
Reputation: 20
#2
2022-04-25, 03:52 PM
I it doesn't look like it. From the circuit diagram, it shows one of the cables in the scanner - display cable as coax. If it were Ethernet, that wouldn't be there.

The further challenge is that JRC radar isn't supported by radar_pi in OpenCPN.
Find
Reply
jim321 Offline
Moderator
*****
Posts: 800
Threads: 46
Joined: Jun 2017
Reputation: 25
#3
2022-04-25, 04:55 PM
https://github.com/opencpn-radar-pi/radar_pi/wiki
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)