2022-05-05, 03:52 PM
Hi,
after my experience with Bulleseye and OP V 3.x I decided to use Buster and OP V 2.x with my Raspberry PI 4.
Unfortunately I'm getting into a boot loop at the beginning of the installation.
Basically there a "two" error messages:
- start4.elf is not compatible
- your board requires a newer software
anyone knows how to fix this?
Thanks
after my experience with Bulleseye and OP V 3.x I decided to use Buster and OP V 2.x with my Raspberry PI 4.
Unfortunately I'm getting into a boot loop at the beginning of the installation.
Basically there a "two" error messages:
- start4.elf is not compatible
- your board requires a newer software
anyone knows how to fix this?
Thanks