This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Autopilot with pypilot and openplotter
Hello everyone!
I want to install an autopilot with open plotter and pypilot, but I need a little help.
I've got...
raspberry pi4
open plotter
motorized arm
simple relay with remote control, of these garage door.
Can I just connect it to the gpio of the raspberry and configure it with pypilot simply?
I need something more?
Thank you very much for your time
You are short of an Inertial Motion Unit (IMU) and a motor controller. Check out here for an introduction You can build them yourself if you are into electronics, but for you I suggest buying them off the pypilot store (

Forum Jump:

Users browsing this thread: 1 Guest(s)