This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
pypilot hat 0.27 keypad connection
I recently purchased a Pypilot Hat version 0.27, and the small motor controller.

The available schematic for the hat is apparently for a previous version.  It shows a connector J1 for a keypad, but there doesn't appear to be a similar connector on the 0.27 Hat.  Is there a convenient way to connect a keypad to this version of the Hat?  There does appear to be a row of holes for external connections on one edge of the board, but any lables for those holes are hidden by the display.
Try this:
Thank you.

It would be helpful if you could put the PCB version number on the schematic.
This is a good idea. I will for the next one.

Forum Jump:

Users browsing this thread: 1 Guest(s)