This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OpenCPN Crashes connected to SignalK
#1
I am having an issue when getting my NMEA data through SignalK.   OpenCPN will lock up after about 5 seconds.   If I delete the signalK connection in OpenCPN and configure it to go directly to my NMEA source there are no issues.

Current SETUP:  
NMEA Source - Miniplex on ethernet - UDP feed on 10110
Data source is NMEA 2000 feed and also AIS
RPI 4 - 4MB

Any recommendations?
Reply
#2
(2022-08-20, 01:53 PM)Bijoux Wrote: Any recommendations?

Sounds like it's the same as this issue discussed on cruisersforum, not read the whole thead  but think a fix was issued?
https://www.cruisersforum.com/forums/f13...ost3647060
Reply
#3
Hello,
After updating opencpn to 5.6.2 and signalk to the latest version, I have problems with the connection in opencpn with signalk through port 3000, since it leaves stucked opencpn, the only solution I have found is to disable the serial connection (nmea0183 with a usb gps) so that the sentences do not reach opencpn.
I have a pican-m hat and I need the signalk connection (3000) to get the nmea2000 sentences (AIS&shipmodul hub), the work around has been to create the serial connection directly gps -> opencpn and keep the signalk connection without GPS data.

David Register has worked on the bug and has published this update, however I can't get it to work on OPV2 32 bits or OPV3 64 bits.
https://launchpad.net/~bdbcat/+archive/ubuntu/opencpn

Can someone help me test this beta? 5.7.1 What should this .deb be? https://launchpad.net/~bdbcat/+archive/u..._armhf.deb

Thank you
Sergi
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)