2023-01-17, 11:56 AM
(2022-12-29, 10:46 PM)jmbwind Wrote: Hi:
NOOB HERE...
I have been wrestling with the BME280 - connected via a FT232H (USB C). and getting:
Checking I2C sensors... | I2C enabled | Access to Signal K server validated
↳openplotter-i2c-read not running
The log shows - BME280 read error: You must first call bme280.ini()
Where do I add this?
Thx.
Similar problem here. BME280 connected through I2C directly on the Raspberry (4), but also get the message
Checking I2C sensors... | I2C enabled | Access to Signal K server validated
↳openplotter-i2c-read not running
and I2C doesn't show up in Signal K
How to solve this?