This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problem with i2c: enabled | not running
#11
(2023-01-24, 06:39 PM)Sailoog Wrote: Are you sure you are using the right adress? this chip usually uses 0x76 or 0x77

I think I did. In fact, in Openplotter I2C screen (see attached), the connection is made. 
.pdf   Naamloos.pdf (Size: 1,019.97 KB / Downloads: 10)
The Openplotter I2C connection is allowed in Signal K, but nothing appears in the Data browser.
Reply
#12
The connection is made even if you add a wrong address, click on "I2C addresses" to see the detected addresses.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)