This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OP 3 and Signal K 1.45 CAN bus
#1
Hello,

my OP 3 on a Raspi 4B 2GB on a MCS board was up and running well together with my seatalk ng network until I updated Signal K to version 1.45.
Now Signal K receives no data anymore from the n2k network.

Has anybody an idea how I can fix that   or
How I can get back to Signal K 1.44?

Regards
Thomas
Reply
#2
my n2k hat works as before. check your cables.
Reply
#3
Definitly not a cable issue
Reply
#4
my CAN0 init looks so:

: dmesg | grep can0

[ 7.582699] mcp251x spi0.0 can0: MCP2515 successfully initialized.
[ 8.706944] IPv6: ADDRCONF(NETDEV_CHANGE): can0: link becomes ready
Reply
#5
I reinstalled Signal K 1.44.0 and the CANBUS data was visible again in CPN. There must be something not running well. I gave it also to the Signal K community but they refuse any issue neither.

Regards
Thomas
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)