2023-01-21, 06:50 PM
Hello Sean, thank for your interest.
I got ethernet using the usb port and a usb to ethernet converter Gigabit Lan Glaabit. If I remember correctly my actions, I just had rewritten the line number 41 in networking.sh (Pypilot 0.32) to change wlan0 by eth0 (mode "Master + Managed"). I started the Tinypilot in Master + managed mode and once running it was possible to stop both wlan0 on Tinypilot in SSH then wlan9 on the Openplotter raspi. That was probably not a very professional approach, I am a real newby.
It was working fine during the last season, unfortunately I loosed that after installation of OP3.
I got ethernet using the usb port and a usb to ethernet converter Gigabit Lan Glaabit. If I remember correctly my actions, I just had rewritten the line number 41 in networking.sh (Pypilot 0.32) to change wlan0 by eth0 (mode "Master + Managed"). I started the Tinypilot in Master + managed mode and once running it was possible to stop both wlan0 on Tinypilot in SSH then wlan9 on the Openplotter raspi. That was probably not a very professional approach, I am a real newby.
It was working fine during the last season, unfortunately I loosed that after installation of OP3.