2023-01-28, 07:23 PM
you should be able to manually assign the interface an ip address then test that it works from both ends using ping etc...
Once this works step by step you could apply the networking script.
Another way to do a wired link is simply use nmea0183. You could wire a usb to serial converter on both computers and connect the serial switching tx and rx. This will only carry nmea0183 data though, so not actual pypilot control, but with a wireless remote it would be enough to get gps and wind data into pypilot.
Once this works step by step you could apply the networking script.
Another way to do a wired link is simply use nmea0183. You could wire a usb to serial converter on both computers and connect the serial switching tx and rx. This will only carry nmea0183 data though, so not actual pypilot control, but with a wireless remote it would be enough to get gps and wind data into pypilot.