This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I2C Support for BME688
#1
This sensor measures temperaturehumiditybarometric pressure, and VOC gas sensing capabilities. I believe support for this sensor would also work for the BME680. I have the development board on order. I have a sensor on hand and would be more than willing to beta test this.

I have special interest in this sensor as I have lost my sense of smell.
Hope to locate a couple of these on the boat:
Near the holding tank, is it leaking?
Bilge, is there propane down here?
Bilge, is there diesel fuel down here?
Head, does it stink in here?
Reply
#2
BME680/688 is in the list of supported sensors in OpenPlotter 3.

Roadmap: https://forum.openmarine.net/showthread.php?tid=3878
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)