2024-03-25, 06:28 PM
(This post was last modified: 2024-03-26, 03:55 PM by captmatto.
Edit Reason: update title
)
Hey all, could someone point me in a useful direction? I have an Autonic masthead wind instrument; I had to place it off-centre because of the masthead setup—my wind instrument is now offset by the degrees off the centreline that we mounted the device.
I only have a one-page instruction sheet (attached) it states:
Input PGNs Custom (PGN: 127257). A 6-byte block of which only the first is used as follows: Set Wind Heading to Zero = 7
Is there a way of using SignalK or something in OpenPlotter to do this? I have Open Plotter running on a Pi-4 and an Actisense NGX-1 via USB to the N2K network.
Many thanks in advance of any pointers
Regards
Matt
I only have a one-page instruction sheet (attached) it states:
Input PGNs Custom (PGN: 127257). A 6-byte block of which only the first is used as follows: Set Wind Heading to Zero = 7
Is there a way of using SignalK or something in OpenPlotter to do this? I have Open Plotter running on a Pi-4 and an Actisense NGX-1 via USB to the N2K network.
Many thanks in advance of any pointers
Regards
Matt
Vessel: Helen Mary R - Bowman 57 - UK Sail Training - Installing Raspberry Pi Nav SystemÂ