This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
Signal K not running after boot from usb

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Signal K not running after boot from usb
mika Offline
Junior Member
**
Posts: 5
Threads: 2
Joined: Jun 2018
Reputation: 0
#1
2023-01-21, 02:23 PM
   

 Hello,

I'm trying to upgrade my system with a new pi 4 and an SSD hard drive. I downloaded the 64 bit headless version and wrote it to an SD card. Booting was fine, no errors. Then I used the SD card copy tool to copy it to the SSD and changed the boot order.
Next I rebooted from the SSD, and updated/installed some apps. Now Signal K is not running -- see the message above. Reinstalling Signal K doesn't help.

Thanks for advice!

Michael
Find
Reply
Sailoog Online
Administrator
*******
Posts: 2,832
Threads: 60
Joined: Mar 2016
Reputation: 266
#2
2023-01-24, 06:26 PM
you probably have reinstalled SK when you already have those apps connected and now they are trying to connect using the old keys. Latest version of openplotter-signalk-installer fixes this, update and reinstall SK from openplotter-signalk-installer, not from the terminal.
Find
Reply
mika Offline
Junior Member
**
Posts: 5
Threads: 2
Joined: Jun 2018
Reputation: 0
#3
2023-02-07, 06:52 PM
(2023-01-24, 06:26 PM)Sailoog Wrote: you probably have reinstalled SK when you already have those apps connected and now they are trying to connect using the old keys. Latest version of openplotter-signalk-installer fixes this, update and reinstall SK from openplotter-signalk-installer, not from the terminal.

thanks, that's what I did -- but SignalK did not start. I now installed the apps and tried the sensor first with the SD card, and copied then to the SSD. Works now fine.

Best, Michael
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)