This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IMU calibration
#1
My setup is 
  • Raspi 4B 8G
  • IMU mpu 9250/6500
  • Open plotter  3.5.0
  • Pypilot 3.2.11

Everything is working fine, thank's to the community.

I have done compass, accel and level calibration in the Calibration window of pypilot.
that's work well pitch and roll are Ok.
To have the right Heading I have to enter a offset of 30.
When I do that pitch and roll do not work well :
rolling the IMU make now moving both roll and pitch data!
It make no sense for me because the offset of the heading should not affect roll and pitch.

How is it working for you?
Reply
#2
It's a known feature of pypilot; see https://forum.openmarine.net/showthread....2#pid17911
Reply
#3
(2023-02-20, 11:20 AM)vincenthure Wrote: To have the right Heading I have to enter an offset of 30.
When I do that pitch and roll do not work well :
rolling the IMU make now moving both roll and pitch data!
It make no sense for me because the offset of the heading should not affect roll and pitch.

Offset of the heading changes the axis relative to which you measure pitch and roll. 
So pitch and roll would change if you modify offset. Only at level zeros would match.
Download BBN Marine OS for raspberry pi 

https://bareboat-necessities.github.io/m...at-os.html

Video of actual installation:

https://www.youtube.com/watch?v=3zMjUs2X3qU


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)