2023-03-01, 02:17 AM
Came across some strange behavior tonight.
Earlier today I was running OpenCPN in OP3, and closed it to do some I2C/CAN hat work. When I went to run OpenCPN again it would not open. Only a quick flash of the "OpenCPN did not close properly, do you want to run in safe mode".
Tried a few things and found out that I could not reopen OpenCPN until I reset the VNC session. Rebooting the PI4 was not enough, had to close the VNC session and then log on again, after that all was fine. The do you want to run in safe mode window did appear, but it ran fine.
Repeatable. If I reboot the Pi using VNC OpenCPN will not open until I sign out of the session and then sign back in.
Earlier today I was running OpenCPN in OP3, and closed it to do some I2C/CAN hat work. When I went to run OpenCPN again it would not open. Only a quick flash of the "OpenCPN did not close properly, do you want to run in safe mode".
Tried a few things and found out that I could not reopen OpenCPN until I reset the VNC session. Rebooting the PI4 was not enough, had to close the VNC session and then log on again, after that all was fine. The do you want to run in safe mode window did appear, but it ran fine.
Repeatable. If I reboot the Pi using VNC OpenCPN will not open until I sign out of the session and then sign back in.