2023-03-12, 11:41 AM
After the latest updates for OP3 32/64bit 7.3.2023 I get Failed to load overlay 'spi-bcm2835'-overlay on start-up. If you want a log or something additional info, please point out the place I can find them.
Failed to load overlay after latest updates
|
2023-03-12, 11:41 AM
After the latest updates for OP3 32/64bit 7.3.2023 I get Failed to load overlay 'spi-bcm2835'-overlay on start-up. If you want a log or something additional info, please point out the place I can find them.
what "the latest updates for OP3 32/64bit 7.3.2023" means? a system update using apt? or you are talking about an specific program being updated?
Can you publish here your file /boot/config.txt? what hardware do you have connected? (2023-03-12, 08:09 PM)Sailoog Wrote: what "the latest updates for OP3 32/64bit 7.3.2023" means? a system update using apt? or you are talking about an specific program being updated? I mean system update with apt. I have OpenPlotter 3 64bit, RaspberryPi 4 with 4GB memory. Pican-M hat with I2C, Sparkfun ICM 20948 and BME280, Logitech Bluetooth mouse and keyboard. OS is run from the USB3 M.2 SSD. Config.txt is attached.
2023-03-12, 10:44 PM
Ok, I mean system update with apt.
PI4 - 4giga - Raspberry Pi 4 Model B Rev 1.4 OP3-32bit I have SSD 120g - Card MCS - MPU 9250 - BMP280 config.txt (Size: 2.33 KB / Downloads: 131)
OK I see that both of you have that MCS board and this line in config.txt: dtoverlay=spi-bcm2835-overlay
what is this overlay for? who is adding this line? I suspect that the software that manages that MCS board is adding this line for a CAN connection but that is not correct. I recommend asking the MCS developers EDIT: sorry Relax does not have a MCS but a PiCAN board but both of them are adding that nonsense line
2023-03-16, 08:09 AM
On some older OS it was needed. I think on newer it makes problems.
I will removed this from the SignalK postinstall. For now you can uncomment it with # or delete it from config.txt
2023-05-11, 12:04 PM
Hello,
Literally just received my new PiCAN-M yesterday... following the SK-Pang manual to install and get it going on my Pi, I edited /boot/config.txt with the following: enable_uart=1 dtparam=i2c_arm=on dtparam=spi=on dtoverlay=mcp2515-can0,oscillator=16000000,interrupt=25 dtoverlay=spi-bcm2835-overlay dtoverlay=spi-bcm2835-overlay generated a "failed to load" message. What was the resolution?
2023-05-11, 02:34 PM
(2023-05-11, 12:04 PM)Johnthebairdsca Wrote: Hello,Just put # before the last line, like this # dtoverlay=spi-bcm2835-overlay Or remove that line, that works too. |
« Next Oldest | Next Newest »
|