RS485 CAN HAT [RESOLVED]

[yiannis]

my config is this for can:
dtoverlay=mcp2515-can0,oscillator=12000000,interrupt=25

for RS485 bluetooth has to be disabled.

holger

On some FB group, people told me that it might be because I am running 64-bit OP. So I did a trial with a 32-bit and it's still the same. I still get the error/warning.

This time I tested if the RS485 works and it's receiving data OK. I cannot test the CAN bus, though.

I tried disabling the Bluetooth, but still no luck. BTW, I am running a Raspberry Pi 4B.

BTW, my CAN HAT has a 16MHz oscillator so I set it to 16000000.

Here you can see the Serial, CAN Bus and System Check applets.