2023-03-20, 12:24 AM
Ok, you have another HAT, but the CAN chip is the same, only other frequency. and you have also 2 serial chips, so forget about bluetooth. i am running also on pi4 with 64bit, so this should work.
what makes me think: the eroor tells about the GPIO conflicts. so there are pins in use which your Hat wants to use.
Check for this in OP-GPIO. And did you enable SPI-Bus in raspi-config?
good luck. Holger
what makes me think: the eroor tells about the GPIO conflicts. so there are pins in use which your Hat wants to use.
Check for this in OP-GPIO. And did you enable SPI-Bus in raspi-config?
good luck. Holger