2023-05-06, 08:14 PM
(This post was last modified: 2023-05-06, 08:17 PM by Boatingbaileys.)
I'm on the boat for a couple of days so let me know how I can check this, however, on the first test that doesn't work on my Seatalk1 network. The LED is more responsive as if it's getting data and SK dashboard shows 0.4 in terms of data throughput. If I leave the invert signal off it's 0 and then with it on it's 0.4 but I dont seem to be getting anything meaningful.
The only thing to say is my board is not powering my Pi yet. They are all hooked up to the same power source however.
Seatalk1 Network - Pi <>ST60 Depth<>ST60 AutoPilot <>ST60 Wind <> C80
I'll change how my pi is powered next and report back again.
The only thing to say is my board is not powering my Pi yet. They are all hooked up to the same power source however.
Seatalk1 Network - Pi <>ST60 Depth<>ST60 AutoPilot <>ST60 Wind <> C80
I'll change how my pi is powered next and report back again.