Boat Instruments Display on m5stack tough

[mgrouch]

Is there NMEA and SignalK traffic from pi?
What is CPU utilization on pi?
Display would keep reconnecting if it
doesn’t receive any messages from those connections
every 3 seconds or so.
Do you have any NMEA devices plugged into your pi?

Is there NMEA and SignalK traffic from pi?

Yes, when it does connect, everything is shown on the M5 Tough

What is CPU utilization on pi?

CPU has low utilization.

Do you have any NMEA devices plugged into your pi?

I am using the signalK to NMEA 0183 plugin, so yes there is NMEA0183. OpenCPN picks it up no problem. Plenty of traffic.

My plan is to make a fresh install of OP3 and see how it goes. This is my test rig so there is a chance something installed or uninstalled incorrectly and is causing an unrelated (to the M5) problem. Won't be able to get to that until next weekend. Will update after further testing.

Also if you do not have Victron CerboGX set Venus MQTT IP address in
m5stack settings to 0.0.0.0. 
It will stop wasting cycles trying to reconnect to
something you do not even have.
And I hope you are using latest version of software
from here

https://github.com/bareboat-necessities/...tack-tough

Version 1.0.2 or later snapshot

---

Is there NMEA and SignalK traffic from pi?
What is CPU utilization on pi?
Display would keep reconnecting if it
doesn’t receive any messages from those connections
every 3 seconds or so.
Do you have any NMEA devices plugged into your pi?

Is there NMEA and SignalK traffic from pi?

Yes, when it does connect, everything is shown on the M5 Tough

What is CPU utilization on pi?

CPU has low utilization.

Do you have any NMEA devices plugged into your pi?

I am using the signalK to NMEA 0183 plugin, so yes there is NMEA0183. OpenCPN picks it up no problem. Plenty of traffic.

My plan is to make a fresh install of OP3 and see how it goes. This is my test rig so there is a chance something installed or uninstalled incorrectly and is causing an unrelated (to the M5) problem. Won't be able to get to that until next weekend. Will update after further testing.

Also esp32 is not good on 5GHz WiFi band. 
You better off connecting to 2.4GHz access point on your boat router 
That’s the band for IoT devices.