(2023-06-15, 06:05 AM)baltika_no_9 Wrote:(2023-06-14, 08:50 PM)gildas declercq Wrote: Hi
just a great debug !
I faced the same issue. rpi4 and a gps hat that i have to connect with usb
I did a setup with openplotter 3 headless before upgrade, all was ok
I did a fresh install of OP3 , did the full upgrade (OS , applications etc) and I was not able to see gps data.
just changed to "remember port" and it worked.
notice tthat when i did in this order
headless fresh install - configure gps usb - upgrade all. I had a message about a lib not upgradable (sorry lost the message) during upgrade/update but it was working
Glad it works for you!
Hello Baltica, Hello all
We had exchanges on that subject a few months ago.
I still have the same problem, no alias created, and remake the conf with "remember port" is not sufficient.
Maybe it's due to my GPS. I add below some infos
About udev:
pi@openplotter:~ $ apt list udev
En train de lister... Fait
udev/oldstable,now 241-7~deb10u9+rpi1 armhf [installé]
pi@openplotter:~ $
About GPS
pi@openplotter:~ $ lsusb
Bus 001 Device 006: ID 1546:01a8 U-Blox AG [u-blox 8]
with dmesg
[ 4.656784] usb 1-1.3: New USB device found, idVendor=1546, idProduct=01a8, bcdDevice= 3.01
[ 4.656811] usb 1-1.3: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 4.656826] usb 1-1.3: Product: u-blox GNSS receiver
[ 4.656841] usb 1-1.3: Manufacturer: u-blox AG - www.u-blox.com
Note that the GPS is seen ad device ttyACM0
Regards
Oups, forget to say RPI3B+, OP3, OCPN 5.8.2