This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
B&G Fastnet protocol to Open Plotter?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
B&G Fastnet protocol to Open Plotter?
KIKEFENO Offline
Junior Member
**
Posts: 1
Threads: 1
Joined: May 2023
Reputation: 0
#1
2023-05-31, 11:51 PM
Hi all!

I have an older B&G wind & depth installation that is based on the Hydra 2000 and  Fastnet bus, but I do not have any FFD NMEA. I am interested in obtaining the Fastnet bus information so that I can connect it to a Raspberry Pi with OpenPlotter, possibly via NMEA. Would anyone be able to assist me with this? How can I insert Fastnet information in OpenPlotter?

Thank you
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)