2023-06-03, 12:08 PM
I have just started on a project using Open Plotter on a RPi 4 and have a similar issue with the GY-91 module.
The version of I2C and PyPilot in the instructions show a 'Connections' tab. However the latest version of both don't have this tab and I therefore don't know how to install the module.
I'm a complete novice so I'm rather stuck. Any advice would be appreciated.
The version of I2C and PyPilot in the instructions show a 'Connections' tab. However the latest version of both don't have this tab and I therefore don't know how to install the module.
I'm a complete novice so I'm rather stuck. Any advice would be appreciated.