2023-06-02, 06:17 AM
I have just installed an A02YYUW Waterproof Ultrasonic Sensor, to measure holding tank level, which connects via UART.
Can anyone tell me how to configure it??
I was thinking I could just set up using Node Red but I cannot find how to get a Signal K path.
I have added to SK in the Serial app but don't know where to go from here!!
TIA
Can anyone tell me how to configure it??
I was thinking I could just set up using Node Red but I cannot find how to get a Signal K path.
I have added to SK in the Serial app but don't know where to go from here!!
TIA