2023-06-29, 03:13 PM
Really struggling with this... I have a PICAN-M on a RPi 4 running OpenPlotter with everything up to date. I have a four port Nmea 2000 backbone:
1. Port 1: Power, (verified that ~13v running through the N2K network)
2. Port 2: PICAN-M+RPi
3. Port 3: Garmin GPS 19x NMEA 2000 antenna
4. Port 4: CX5003 NMEA 2000 sensor unit with voltage being monitored
5. Terminators at both ends, no open ports.
I've followed and refollowed the PICAN-M setup and everything is configured.
The Problem: No traffic on a CANDUMP. I see nothing, just a blank screen.
The PICAN-M manufacturer said that as long as there isn't an error on the CANDUMP, THEIR unit is working.
This is a test setup so I don't have another device (like an MFD) to test N2K.
Any ideas?
1. Port 1: Power, (verified that ~13v running through the N2K network)
2. Port 2: PICAN-M+RPi
3. Port 3: Garmin GPS 19x NMEA 2000 antenna
4. Port 4: CX5003 NMEA 2000 sensor unit with voltage being monitored
5. Terminators at both ends, no open ports.
I've followed and refollowed the PICAN-M setup and everything is configured.
The Problem: No traffic on a CANDUMP. I see nothing, just a blank screen.
The PICAN-M manufacturer said that as long as there isn't an error on the CANDUMP, THEIR unit is working.
This is a test setup so I don't have another device (like an MFD) to test N2K.
Any ideas?