2023-08-23, 01:19 PM
I am currently attempting to connect my DST800 Triducer (NMEA 0183) to my OP V2 using a USB to RS422 adapter. I have correctly connected the wires (R+ and R-), and the Receive LED is flashing red. The Transducer is receiving 13V power. The OP V2 recognizes the Triducer in the serial tab, and I have connected it to serial K with a baud rate of 38400 Baud. However, when I added it to OPEN CPN under connections, it was recognized at 4800 baud. Unfortunately, I am not receiving any response for temperature, depth, or speed. It's worth mentioning that I'm conducting these tests in my office before installing the system. I am using an RPI V3b+ and the Serial GPS works fine. As I am not very familiar with this process, I suspect that I might be overlooking something important. Can anyone please offer some guidance or assistance?