This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[SOLVED] 0.11.4 I2C issue
#1
Hi

I've upgraded from 0.11.3 to 0.11.4 and whilst I can see and set up the I2C sensors when I run the SK diagnostic no information is appearing. The IMU appears in the calibration unit so I know its working. It also works fine in 0.8.0

I've tried reinstalling from 0.10.0 bur that had made no difference.

I tried running in debug mode and got this "pi@openplotter:~ $ python /home/pi/.config/openplotter/openplotter.py
python: can't open file '/home/pi/.config/openplotter/openplotter.py': [Errno 2] No such file or directory


I have a pi 3 with no other addons

Is there something I'm missing ?

Rgds

Keith
Reply
#2
You have to double click over the created sensor and there you have to assign a signal k key to each magnitude the sensor can manage:
navigation.headingMagnetic
navigation.attitude.roll
navigation.attitude.pitch

to debug type just "openplotter" in a terminal
Reply
#3
(2017-05-11, 03:24 PM)Sailoog Wrote: You have to double click over the created sensor and there you have to assign a signal k key to each magnitude the sensor can manage:
navigation.headingMagnetic
navigation.attitude.roll
navigation.attitude.pitch

to debug type just "openplotter" in a terminal

That fixed it Smile  Thanks for quick response

keith
Reply
#4
Marking this as [SOLVED]. We will try to improve our documentation soon.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)