airmar pb100 with combiner

[ddelorme]

i noticed a used Airmar ultrasonic weatherstation with a combiner at a used marine store today so i bought it.
i am having a little problem getting data off of it. it has a usb output and openplotter sees it. the docs say to use 57600 with the combiner when i run cat /dev/the device i see gibberish and the light on the device is blinking like it should. so i am assuming data is coming from the device..
my question is their a linux command i can use to see the nmea stream so i can tell if it is actual working?

signalK is not getting any data

[ddelorme]

i noticed a used Airmar ultrasonic weatherstation with a combiner at a used marine store today so i bought it.
i am having a little problem getting data off of it. it has a usb output and openplotter sees it. the docs say to use 57600 with the combiner when i run cat /dev/the device i see gibberish and the light on the device is blinking like it should. so i am assuming data is coming from the device..
my question is their a linux command i can use to see the nmea stream so i can tell if it is actual working?

signalK is not getting any data

so i found the answer i used minicom the document i had was wrong the baud rate was 38000. now it is outputting data. very cool now i need to mount and test to see if it is showing correct data. it has been a while dealing with hardware and software as i have been doing other maintenance to my alberg 37. i also scored a e85001 so i can convert old seatalk data to my system.