This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1 wire temp on OpenCPN Dashboard
#1
Hi All,
I am having a bit of a problem that I hope someone here will have a solution to.
I have a Rpi4 b running OpenCPN 5.8.4 and I want to display engine temp on the OpenCPN dashboard. Is there a specific Signal K key that I should use to get it to display ?
I'm using a 1 wire DS18B20 temp sensor. It shows up in the Signal K Data Browser.
I hope I just need the correct SK key.
Thanks in advance.
Pi5 8Gb, NVMe Base 265Gb, MacArthur Hat, Daisy Hat, PyPilot controller, 15.6" Sihovision 1000Nits Touchscreen.
Reply
#2
OK... Newbie mistake..Decided to use DashboardSK
Cheers!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)