Hi,
The message of compas distortion is also showing up on my calibration plot page. And what i understood from Sean, is that this meassage might not be an issue!?
Do the readings of the compass direction change fluently when rotating the imu?
regards,
Wouter
I've been testing this beta also. And I found that the standard gpio pins are not programmed in the hat.conf. And as the interface http://pypilot.io:33333/ didn't show the buttons when pressed, I modified the hat.conf in the terminal editor. This seem to work as the buttons are now mapped, and this is shown in the webinterface. The only thing now is that a button press seems to be lagging. I have to do a long press to activate the menu button, standby button etc. This is not so much an issue for the mentioned buttons. Howver, it is an issue for the +1 and -1 button. As this would trigger a +10 and -10 on the course adjustment. And not just -1 and +1 course adjustment.
Not sure what is going on there...
regards,
Wouter
The message of compas distortion is also showing up on my calibration plot page. And what i understood from Sean, is that this meassage might not be an issue!?
Do the readings of the compass direction change fluently when rotating the imu?
regards,
Wouter
I've been testing this beta also. And I found that the standard gpio pins are not programmed in the hat.conf. And as the interface http://pypilot.io:33333/ didn't show the buttons when pressed, I modified the hat.conf in the terminal editor. This seem to work as the buttons are now mapped, and this is shown in the webinterface. The only thing now is that a button press seems to be lagging. I have to do a long press to activate the menu button, standby button etc. This is not so much an issue for the mentioned buttons. Howver, it is an issue for the +1 and -1 button. As this would trigger a +10 and -10 on the course adjustment. And not just -1 and +1 course adjustment.
Not sure what is going on there...
regards,
Wouter