2017-05-26, 11:49 PM
An update to my previous issues:
I tried rate limiting my graphing attempt to one data point per second but SignalK still crashed.
Starting with the default Node Red flow that comes with OpenPlotter 0.11.7 (I added my wind speed graph to the default stuff) I attempted to trace the crashing and started systematically removing the flow lines between nodes.
For reasons unknown to me, the flow has decided to run just fine now without any additional crashing. The only thing I did is remove all interconnections between nodes and then adding them back in gradually to see where it starts crashing.
I also found that the standard graph presentation is a running window as I wanted to implement - bonus!
At this point, all I can do is play and observe to see if I can recreate any crashing.
I tried rate limiting my graphing attempt to one data point per second but SignalK still crashed.
Starting with the default Node Red flow that comes with OpenPlotter 0.11.7 (I added my wind speed graph to the default stuff) I attempted to trace the crashing and started systematically removing the flow lines between nodes.
For reasons unknown to me, the flow has decided to run just fine now without any additional crashing. The only thing I did is remove all interconnections between nodes and then adding them back in gradually to see where it starts crashing.
I also found that the standard graph presentation is a running window as I wanted to implement - bonus!
At this point, all I can do is play and observe to see if I can recreate any crashing.