I did that, and now I am getting this error: SIOCGIFINDEX: No such device. And still no CAN lights.
I checked my boot/firmware/config.txt and found the entry. Should I add can0 there, too? (I tried that, and it did nothing.)
And when I do as you suggested, I have two MCP251xfd entries. One is the original, with a connection, oscillator, and interrupt but with no interface or SK connection ID. The other is one set up in SK with no connection, oscillator, or interrupt, but it does have an interface and SK connection ID value.
PS Is it better to report this type of issue here or on Git?
I checked my boot/firmware/config.txt and found the entry. Should I add can0 there, too? (I tried that, and it did nothing.)
And when I do as you suggested, I have two MCP251xfd entries. One is the original, with a connection, oscillator, and interrupt but with no interface or SK connection ID. The other is one set up in SK with no connection, oscillator, or interrupt, but it does have an interface and SK connection ID value.
PS Is it better to report this type of issue here or on Git?