Posts: 3
Threads: 1
Joined: Feb 2024
Reputation:
0
How to connect pypilot motor controller to the MacArthur hat? On the motor controller has +3.3V, tx, rx and gnd lines, I try to connect NMEA 0183 data flow. Is this possible at all or need to connect directly to the Rasperry pi?
I can't find any basic instructions anywhere, looks like documentation is before than MacArthur hat entered on market.
Posts: 2,836
Threads: 60
Joined: Mar 2016
Reputation:
267
2024-03-04, 05:52 PM
(This post was last modified: 2024-03-04, 05:54 PM by Sailoog.)
You have to connect the pypilot motor controller to UART0 using the Raspberry pin header.
If you use UART0 for pypilot you can not use a MAIANA transponder or a dAISy HAT. If you need UART0 for one of these devices you can also use UART2 in Raspberry 4 (GPIO 0 and GPIO 1) or UART1 in Raspberry 5 (GPIO 0 and GPIO 1) for your pypilot controller.
Posts: 2,836
Threads: 60
Joined: Mar 2016
Reputation:
267
I think you need dtparam=uart0_console only if you want to use the new three-pin JST-SH connector in RPi5. If you needed that for using UART0 in pypilot, it could be because the pypilot code is not yet updated to RPi5.