This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › MacArthur HAT › How I did it
Pi5, NVMe Base, OpenPlotter, MacArthur HAT - Build

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Pi5, NVMe Base, OpenPlotter, MacArthur HAT - Build
AndyV Offline
Junior Member
**
Posts: 20
Threads: 3
Joined: Jan 2024
Reputation: 0
#6
2024-03-31, 02:40 AM
This is a first Pi build for me, I've got the pi5 with active cooler, NVME base with SSD below and considering the MacArthur Hat with the power module. Do I need anything aside from the MacArthur hat to make this fit (for example, will the gpio pins from the MacArthur Hat reach the Pi5's gpio pins with the Pi5 Active Cooler installed? Thanks!
Find
Reply


Messages In This Thread
RE: Pi5, NVMe Base, OpenPlotter, MacArthur HAT - Build - by AndyV - 2024-03-31, 02:40 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)