This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
SignalK alarms

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
SignalK alarms
Boatingbaileys Offline
Member
***
Posts: 189
Threads: 16
Joined: Nov 2020
Reputation: 18
#1
2024-03-17, 09:26 PM
I have a Pilot Off Course alarm when my autopilot is in standby and it just reports as a visual alarm in SK but in AvNav it constantly pops up. Is there a way in SK to filter or change the alarm if standby is also detected. Not something I’ve done before so any pointers would be appreciated.

I’ve asked the question on Discord but now response so thought I would try here.
Website Find
Reply
Osr75 Offline
Junior Member
**
Posts: 10
Threads: 3
Joined: Sep 2022
Reputation: 0
#2
2025-01-09, 07:48 PM
Hello! I have the same problem. I set up a temperature alarm using zones in SK. Kip works perfectly: when the alarm is on, Kip notifies me, and when the alarm is off, Kip stays quiet. However, AvNav never stops the pop-ups... Did you manage to solve this?

Thanks a lot in advance!
Find
Reply
Boatingbaileys Offline
Member
***
Posts: 189
Threads: 16
Joined: Nov 2020
Reputation: 18
#3
2025-01-10, 05:49 PM
Hi, No i didn't. I'll try to pick it up again.
Website Find
Reply
Osr75 Offline
Junior Member
**
Posts: 10
Threads: 3
Joined: Sep 2022
Reputation: 0
#4
2025-01-13, 09:19 PM
(2025-01-10, 05:49 PM)Boatingbaileys Wrote: Hi, No i didn't. I'll try to pick it up again.


Thanks for your missage! 

I think I solve!!!!
You shoud go to SERVER STATUS  and in    AVNSignalKHandler (item 11) you should add the user and password for Signal K! That solve it for me!
 
By other way thanks also for your videos!!!!
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)