This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
N2K power/on-off-on switch
#1
I want to install a switch that will allow me to power up regardless of whether the N2K network is connected. I want this while testing when the N2K network isn't needed.

ON 1 - Would power up with 12VDC to the switch connector on the MacArthur directly from the primary 12VDC source. 
OFF - No power; RPI5 would not power up
ON 2 - Would power up with 12VDC to the switch connector on the MacArthur from the N2K drop.

I don't see a reason or problems with this setup.

Pax,
Mo
Reply
#2
Something like this?

https://macarthur-hat-documentation.read...alone-mode

[Image: n2k-dcdc-ind.png]
Reply
#3
Ah, yes. And more graceful than my thinking, too. Thanks.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)