2024-08-23, 07:33 PM
Hello everyone.
My current setup is as following:
Rpi5/4Gb + 256Gb M:2 SSD
McArthur hat
OP4
Data to OpenPlotter is fed from N2K network into SignalK. The entire setup is working fine. OpenCPN talks to SignalK, I can see all data etc
I also chose to use InfluxDB 2 + Grafana for historical statistics. I opted for an option to leverage InfluxDB2 plugin to send *all* data to InfluxDB2 from SignalK since I have lots of available storage.
The issue: The SignalK InfluxDB2 plugin frequently stops sending data to Influx. It works for a while and then it just stops. This typically happens when I stop and restart RPI but I think there are also other scenarios which causes data flow from SignalK to Influx to stop.
So far , the only recourse that I know of is to keep clicking on the "Submit" button from the Inflluxdb2 plug-in configuration but it does not last long and I often forget to so so.
Previous system (OP3+RPI4) did not have this issue.
Thanks in advance
Nick
My current setup is as following:
Rpi5/4Gb + 256Gb M:2 SSD
McArthur hat
OP4
Data to OpenPlotter is fed from N2K network into SignalK. The entire setup is working fine. OpenCPN talks to SignalK, I can see all data etc
I also chose to use InfluxDB 2 + Grafana for historical statistics. I opted for an option to leverage InfluxDB2 plugin to send *all* data to InfluxDB2 from SignalK since I have lots of available storage.
The issue: The SignalK InfluxDB2 plugin frequently stops sending data to Influx. It works for a while and then it just stops. This typically happens when I stop and restart RPI but I think there are also other scenarios which causes data flow from SignalK to Influx to stop.
So far , the only recourse that I know of is to keep clicking on the "Submit" button from the Inflluxdb2 plug-in configuration but it does not last long and I often forget to so so.
Previous system (OP3+RPI4) did not have this issue.
Thanks in advance
Nick