This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Bug Reports v
editing ic2 value clears all sensors

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
editing ic2 value clears all sensors
ckoissa Offline
Junior Member
**
Posts: 5
Threads: 0
Joined: Mar 2024
Reputation: 2
#8
2024-11-13, 02:21 PM (This post was last modified: 2024-11-13, 02:24 PM by ckoissa.)
Hello,
I also have this same problem: impossible to enter a SK key for the ADS1115 sensor. This erases all other I2C sensors.
Have you found a workaround other than going back to V3?
My configuration: OP4 on RPi5/NVMe Pimoroni + Mac-Arthur hat
Thanks
Find
Reply


Messages In This Thread
RE: editing ic2 value clears all sensors - by ckoissa - 2024-11-13, 02:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)