editing ic2 value clears all sensors

[Kit_buyer]

I had very strange behavior on the i2c bus with an RPI5. It would not tolerate any run greater than 200mm and once I broke the 4-5 mark on i2c devices it became very unstable and acted erratic.

Adding an Adafruit LTC 4311 Active I2C terminator resolved the issue. May not be your problem but it is worth a try.

Hi. Thank you for the suggestion, I added the LTC 4311 I2C terminator to see if it might work and re-tested the system. In this case it didn’t resolve the issue.

 I hope it is a minor software incompatibility in the change from OP3 to OP4 which can be found soon. I will try using an ADS1015 in the meantime and see if those are compatible with OP4. 

I will report back with my findings, don’t hold your breath though it could take me some time.