This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I2C enclosure
#1
Not sure if this fits well under MacArthur enclosure. If not, feel free to punt me in the right direction

I was sticking my I2C components on generic small plastic boxes but it was bugging me, especially for the IMU that I wanted as square as possible.

I printed a minimalistic box, I'm open to suggestions for improvements.  Maybe add a lip for a butyl bead and a built-in Deutsch connector  Deutsch connector Deutsch c

https://makerworld.com/en/models/739572


Attached Files Image(s)
   
Reply
#2
Cute! Thanks for sharing Smile

Are the two halves held together with screws, or are they friction-fit?
Reply
#3
Thanks!

Friction fit. The two indentations on the sides of the bottom part are to insert a screwdriver blade to twist them open, it's pretty tight. Getting the PCB out also requires some finesse.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)