2024-12-19, 12:25 AM
Greetings,
Very new to OpenPlotter, so hoping someone can help with a configuration. I am trying to connect a BME 680 sensor using the I2C 4.2.0 utility. When I check I2C Addresses, my sensor correctly maps to 0x77. When I add the BME 680/688 in the Supported Sensor drop down, and 0x77 in the Detected Addresses drop down, I get an error message stating “Error processing BME 680/688: Failed to find BME680! Chip ID 0x41”. I do not have any device at the 0x41 address. Any help would be greatly appreciated!
Very new to OpenPlotter, so hoping someone can help with a configuration. I am trying to connect a BME 680 sensor using the I2C 4.2.0 utility. When I check I2C Addresses, my sensor correctly maps to 0x77. When I add the BME 680/688 in the Supported Sensor drop down, and 0x77 in the Detected Addresses drop down, I get an error message stating “Error processing BME 680/688: Failed to find BME680! Chip ID 0x41”. I do not have any device at the 0x41 address. Any help would be greatly appreciated!