This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
powermodule connecting how?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
powermodule connecting how?
wimsl Offline
Junior Member
**
Posts: 10
Threads: 4
Joined: Jan 2018
Reputation: 0
#1
2025-01-07, 08:05 PM (This post was last modified: 2025-01-07, 08:06 PM by wimsl.)
got the hat, powermodule but how to connect it to the board? it looks the risersand or screws dont fit in the holes.
or are there other sizes available on the net?


Attached Files Image(s)
   
Find
Reply
Adrian Offline
Member
***
Posts: 185
Threads: 2
Joined: Mar 2023
Reputation: 16
#2
2025-01-07, 10:56 PM
Note that there should be two diameters of screws and stand-offs in the kit. For the power module you have to use the smaller/thinner ones.
   
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)